A pepper, lots of tabaco and a baking device is all you need before you even think off beginning such install./PPTime of installation: 6 evenings

This basically was the old installation, I just smashed everything in to get a quick glance of how it would sound. The power was far to much to have in a normal install so I had a lot of vibrations, removing old...

5 meters of 2mm thick rubbers and a MDF plate of 18mm. The rubbers will go everywhere (trunk, dash and doors) and the plate will replace the floormat currently in the trunk.

The plate

Stuff that will go in

One clean and bare trunk

Putting in the rubber, this is the first layer in the trunk (three where done)

This is one side with two layers and one side with one layer with dynamat underneath it (place where sub comes)

This picture is with three layers in the trunk

Take out the chainsaw and make things happen !/PPLots of measuring and just sawed the plate

The plate in its to be placed form, two bars are added to make it more stable, also again lotsa rubber on the bars

The bars

The plate putted in, a crossover is placed underneath the plate, also an rca amplifier to get more connections is placed there, cables are separated from each other with cable shields

It actually fitted !!!

Made a nice and cosy place to put the sub so it wouldnt move

Testing some possible locations and mounting the rca holes

Dynamat with normal rubber on top of it for the sub bracket place

Digicam went low so had to reduce picture interval, here i place the two phoenixs (who power the tweeters, front speakers and rear speakers, 2x50 and 2x25) and coated it with red carpet, also cables where put in place

The view of the last situation of fase 2, this is what you saw when you simply open the trunk

This is after removing the pads that lie on the plexiglass covers./PPChanges made after this:/PP- Capacitator place on right side, right side itself covered with one board that runs straight to the eh... hoedenplank? :)BR- Left side also has such board place (coated with black carpet) and has some measuring instruments in it (heat and voltage measuring) with a digi display (will place pics next week)BR- PC cooling fans where place in the room between the boards (4 pieces)BR- Last two visible cables removed from sight (rear speaker cables)